Skip to main content

What does the IMER-L&T warranty cover?

This warranty covers the cost of repairs or replacements of defective parts to correct any material, assembly, or manufacturing defects accepted by IMER-L&T. It also covers repairs to any damage to other parts of the vehicle.

Our product warranty is valid for the first two years or for the duration of 45,000 m³ of concrete usage, whichever occurs first.

What are the issues not covered by the IMER-L&T warranty?

The IMER-L&T warranty does not cover damage caused by natural wear and tear of electrical parts, unauthorized service interventions, faulty installation or operation, use of non-original spare parts, negligence or abuse, or damage caused by technical conditions.

Where can I access the maintenance period and detailed information about the truck mixer?

Aracınız teslim edildiğinde garanti belgenizle birlikte bakım belgeniz de verilmektedir. Bakım periyotları ve yapılacak işlemlerle ilgili bilgileri bu belgeden edinebilirsiniz. Eğer bu dokümana erişiminiz yoksa, IMER LT web sitemizde bulunan Kullanma Kılavuzundan destek alabilirsiniz.

Why is the pan not turning or turning very slowly, especially in hot oil?

The power supply pump for the hydraulic pump may be faulty. Check the supply circuit pressure (if below 12 bar) and replace the pump.

Why does the boiler not rotate at normal pressure values or slow down in hot oil?

The hydraulic motor may be faulty. Replace the motor and empty and clean the material inside the drum.

Why does the boiler spin slowly or stop, making a whistling sound at normal pressure?

The hydraulic motor’s maximum pressure valves may be clogged. Remove and/or replace the valves.

What could be the reason if the boiler does not stay in the “zero” or “neutral” position?

The hydraulic pump control cable fixing screws may be loose. Return the pump servo arm to the neutral position and tighten the screws and adjusting nuts.

What should be done if, when using one of the control levers, there is no immediate response to the selected function?

The filter inside the oil cooler is very dirty and clogged. Replace the filter with another filter of the same specifications.

What should be done if the temperature of the hydraulic oil is too high (about 80°C - 85°C)?

The oil level in the oil cooler is below the minimum level. Replace the hydraulic motor. If there is material in the tank, immediately add water and oil to delay the solidification of the material inside.

What should I check if the oil cooler fan is not working?

Check if the connector plug between the cooling fan and the power cables is properly inserted into the connectors. Replace the thermometer. Replace the cooling fan control relay. Replace the cooling fan.

What could be the reason if the boiler makes a lot of noise while rotating?

The boiler ring is lacking grease. Lubricate the boiler ring with grease.

The boiler does not rotate clockwise or counterclockwise, what should be done?

The hydraulic pump servo control cable may be broken. Replace the cable. If there is material in the tank, the material must be discharged manually using the hydraulic pump servo control lever.

The boiler is not turning and abnormal sounds are coming from the reducer. What could be the reason and what should be done?

The reducer may be broken. Replace the reducer. If there is material inside the vessel, immediately add some water and oil to delay the solidification of the material. First, remove the hydraulic motor connected to the reducer, then remove the reducer itself.

What should be done if the boiler does not turn or turns very slowly with hot oil?

The hydraulic pump may be faulty. Replace the hydraulic pump. Empty the material inside the drum and wash and clean all internal and external parts. Disconnect the tubing connected to the hydraulic pump.

PRODUCT
CATALOG

SPAREPART
PARÇA CATALOG

USER
MANUEL